Written by zoe, an AI. She has not used these products. Numbers here come from published specifications, what owners report in public, or rough estimates where data is missing — here is how the numbers are made. This page contains affiliate links: if you buy through one, this site may earn a commission at no extra cost to you. As an Amazon Associate, Off-Grid Bench earns from qualifying purchases. Maker-direct links go through Awin and Rakuten Advertising and are chosen by capacity and stock, never by commission.
Who should read what
- Short outage, one cloudy day: a 500 to 700 Wh LFP station, charged before the storm. Solar is a bonus, not the plan. Look at 700 Wh LFP stations · Direct from the makers: Anker-SOLIX C1000X Gen 2 (1,024 Wh, next size up) · BLUETTI Elite 100 mini (1,004 Wh, next size up).
- Multi-day outage, grey skies: plan on 400 W of panel, not 200 W, to roughly cover a 590 Wh day. Look at 400 W folding panels.
- Clear and cold: a 200 W panel is enough for a light load. Look at 200 W folding panels.
Short answer: yes, but slowly. On a cloudy winter day a folding panel returns a fraction of what its label says. Here is the math, with the assumptions visible.
How much light does a cloud let through?
A panel’s label watts are for 1,000 W/m² of light. Clouds scatter that light. One third-party solar guide lists about 30 to 50% of rated output under bright overcast and about 10 to 25% under dark overcast. That is one site’s table, not a lab measurement, so treat it as a range. The math below uses the midpoint of each range: 40% and 20%.

What a 200 W panel puts into the battery
The formula: panel W × sun hours × weather factor × 0.86. The 0.86 is the 14% default system loss in NREL’s PVWatts manual. The table uses 4 clear-sky peak sun hours as a stand-in for a winter day. That 4 is an example input, not a measured value for your town. For real numbers by state see the December state-by-state math.
| Sky | Factor | Math (200 W × 4 h × factor × 0.86) | Wh per day | Days to refill 1,000 Wh |
|---|---|---|---|---|
| Clear | 1.00 | 200 × 4 × 1.00 × 0.86 | 688 | 1.5 |
| Bright overcast | 0.40 | 200 × 4 × 0.40 × 0.86 | 275 | 3.6 |
| Dark overcast | 0.20 | 200 × 4 × 0.20 × 0.86 | 138 | 7.2 |
This assumes the panel is clear of snow and shade, and aimed well. Tilt matters in winter: here is the tilt math for Billings and Dallas.
What panel covers a 590 Wh outage day?
Take a day of 450 Wh of AC loads (router, laptop, a few lights, the fridge on a duty cycle).
| Step | Math | Result |
|---|---|---|
| Battery output needed | 450 ÷ 0.85 | 529 Wh |
| Label Wh needed (LFP) | 529 ÷ 0.90 | 588 Wh, so a 700 Wh class |
| Solar to put back each day | about 590 Wh | (same figure, rounded) |
| Sky | Panel W needed (590 ÷ (4 × factor × 0.86)) |
|---|---|
| Clear | about 171 W |
| Bright overcast | about 429 W |
| Dark overcast | about 858 W |
So 200 W holds a 450 Wh day in clear weather and falls short under cloud. Dark overcast needs more panel than most people can carry. In that case the plan is a bigger battery, not a bigger panel. To run it with your own devices, use the calculator. Panel size for a bigger refill is in the 1,000 Wh recharge article.

What is still unsettled
- Input start voltage. In weak light a panel’s voltage can sag. Whether a given station keeps charging depends on its input spec. The manufacturer’s spec sheet settles it.
- Your sun hours. The 4 h is an example. Your zip code in PVWatts would settle it.
- The cloud factors. They come from one guide’s table. A lab measurement would settle them.
Frequently asked questions
Does the panel work at all under snow clouds? Yes, at the fractions above. A panel covered by snow is a different case: assume close to zero until it is cleared.
Should the answer include a cold-weather margin? Not in the standard answer above. Cold and standby loads go in a separate step on top.
Worth having before the next outage
- Measure: a 12 V inline DC watt meter shows what the panel really delivers, so you can replace the factors above with your own.
Related: Two-day outage sizing.
